Elo-touchsystems ET1566L-7SWC-1 Manuel d'utilisateur télécharger pdf (Page 16)

2-11

STEP 3-Connecting the Power Cable

Depending on where you live, you will use either the European or US/Canadian

power cable.

• Connect the female end of the power cable to the Brick power supply.

• Connect the Brick power supply into the power port on the touchmonitor.

To protect your equipment against risk of damage from electrical surges in the power

line, plug the brick supply’s power cord into a surge protector, and then connect the surge

protector to a grounded (three-pronged) AC electrical outlet.

• Power on your PC then your touchmonitor. After a brief pause the picture

should appear.

• The power can be turned on and off by the small white switch on the back of

the touchmonitor. The touchmonitor can also be turned on and off by

plugging and unplugging the power cable.

Optimizing the LCD Display

To ensure the LCD display works well with your computer, configure the

display mode of your graphic card to output 1024 x 768 resolution, and make

sure the timing of the display mode is compatible with the LCD display. Refer

to Appendix A for more information about resolution. Compatible video modes

for your touchmonitor are listed in Appendix C. Refer to Chapter 3 for more

information on adjusting your touchmonitor’s video characteristics.

Connections on underside

Power

cable

Power switch

Power

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 43 44

Pas de commentaire

Elo-touchsystems ET1566L-7SWC-1 Manuel d'utilisateur Page 16