Elo TouchSystems MonitorMouse FOR WINDOWS NT Version 2.0 Guide de l'utilisateur télécharger pdf (Page 109)

Port Powered Swipe Reader

Figure 2-1. Mounting Hole Dimensions For Surface

3. Mount the Reader.

INSTALLATION AND TEST

To install the Swipe Reader, perform the following steps:

1. Connect the Swipe Reader cable connector into a 9-pin serial Com Port on the PC. If a

25-pin Adapter is required, plug the 9-pin connector on the Reader into the Adapter, and

the adapter into the PC.

2. Open a communications program such as the Mag-Tek Encoder/Reader Demonstration

Program, which may be obtained from the Internet at www.magtek.com. Navigate to the

Demo Programs and select Reader & Encoder Demos (Win 95/98/NT).

3. On the program, select the Com Port the Reader is connected to.

4. If the Com Port selected is correct, the green LED on the Reader will light; if the wrong

Com Port is selected, the LED will not light.

5. Select the baud rate of 9600.

1 2 ... 104 105 106 107 108 109 110 111 112 113 114 ... 248 249

Pas de commentaire

Elo TouchSystems MonitorMouse FOR WINDOWS NT Version 2.0 Guide de l'utilisateur Page 109