Elo TouchSystems TouchSystems CarrollTouch Prog Guide de l'utilisateur télécharger pdf (Page 16)

CARROLL TOUCH Chapter 1 - Introduction

Touch System Diagnostics (CTDIAG) User’s Guide 1-5

Figure 1-1. Example CTDIAG Menu

• The Status line summarizes the configuration and communication

parameters for the touch system currently in use. In Figure 1-1, the

left portion of the Status line reports a configuration of the direct

interface method and a hardware-based controller. The right portion

indicates the I/O address and hardware interrupt request number.

If the example were for a serial (RS-232) controller, the right portion of

the Status line would list these communications parameters: comm port,

I/O address, hardware interrupt request number (IRQ), baud rate, parity,

data bits (fixed at 8), and stop bit. These parameters are defined and

described in Chapter 4, “Setting Communication Parameters.”

If a TAPI driver is loaded, the right portion of the Status line indicates

the software interrupt where the driver is installed.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 91 92

Pas de commentaire

Elo TouchSystems TouchSystems CarrollTouch Prog Guide de l'utilisateur Page 16