Elo TouchSystems TouchSystems CarrollTouch Prog Guide de l'utilisateur télécharger pdf (Page 58)

CARROLL TOUCH Chapter 8 - TAPI Debug

Touch System Diagnostics (CTDIAG) User’s Guide 8-3

ltapi.bat

If the driver does not install correctly, check all communication

parameters, then refer to the

Touch System Programmer’s Guide

for

additional information.

2. Start CTDIAG and use TAPI interrupt as the interface method. You

can specify TAPI interrupt as a command line option (ctdiag

i:T; see Chapter 9 for details) or in the CTDIAG.CFG

configuration file (see Appendix B for details). The Test menu

appears. Otherwise, select the TAPI interrupt interface method from

the Test Configuration Menu, then advance to the Test menu.

3. Select Debug from the Test Menu and press F10 to start TAPI

Debug. As shown in Figure 8-1, CTDIAG prompts for the

hexadecimal AX register value in the Message line.

Figure 8-1. SFP TAPI Debug Screen

4. Type 4 to select TAPI function 4,

GetCommunicationParameters

CTDIAG loads the value 4 into the AX register, then prompts you

to:

Enter the BX regs in HEX:

5. Because AX is the only call needed for this function, press ENTER to

accept the default value of 0H for the BX register. When prompted,

press ENTER to accept the default value of 0H for the CX and DX

registers, as well.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 91 92

Pas de commentaire

Elo TouchSystems TouchSystems CarrollTouch Prog Guide de l'utilisateur Page 58